eLibrary >
BS 5911-3:2010+A1:2014 Concrete pipes and ancillary concrete products - Specification for unreinforced and reinforced concrete manholes and soakaways (complementary to BS EN 1917:2002) >
BS 5911-3:2010+A1:2014 Concrete pipes and ancillary concrete products - Specification for unreinforced and reinforced concrete manholes and soakaways (complementary to BS EN 1917:2002), 2014
- Foreword
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Symbols
- 5 General requirements
- 6 Special requirements
- 7 Conformity evaluation
- 8 Marking
- Annex A (informative) Information to be supplied in an enquiry or order
- Annex B (normative) British Standards relevant to BS EN 1917:2002
- Annex C (normative) Surface void test
- Annex D (normative) Dimensional tests
- Annex E (normative) Lifting anchorage pull-out test
- Annex F (informative) Assessment of strength class for rectangular shaft units when considering permissible installation depth
- Bibliography
- Figure 1 Use of corbel slabs in conjunction with double steps or ladder [Go to Page]
- Table 1 Limiting values of composition and properties for concrete where a DC‑class is specified
- Table 2 General purpose cements and combinations
- Table 3 Nominal sizes, internal manufacturing diameters and tolerances of circular units
- Table 4 Nominal sizes, internal manufacturing sizes and tolerances of rectangular units
- Table 5 Shape, size and position of openings in cover slabs, adjusting units and corbel slabs
- Table 6 Shape, size and position of openings in reducing and landing slabs
- Table 7 �Strength classes and corresponding minimum crushing loads for circular and rectangular chamber and shaft units
- Table 8 �Vertical proof loads for cover, reducing and landing slabs to fit chambers greater than DN 1250 and corbel slabs
- Table A.1 Information to be supplied in an enquiry or order
- Table B.1 British Standards relevant to BS EN 1917:2002 [Go to Page]