eLibrary >
BS EN 50193-2-1:2016 Electric instantaneous water heaters - Methods for measuring the performance. Multifunctional electric instantaneous water heaters >
BS EN 50193-2-1:2016 Electric instantaneous water heaters - Methods for measuring the performance. Multifunctional electric instantaneous water heaters, 2016
- European foreword
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- Figure 101 [Go to Page]
- Table 101 – Symbols and units
- 4 General test conditions [Go to Page]
- 5 Energy efficiency
- 6.101 Performance tests [Go to Page]
- Table 102 – Nominal values for electronically controlled or regulated appliances [Go to Page]
- Table 103 – Nominal values for hydraulically controlled appliances [Go to Page]
- Table 104 – Flow pressure and flow rate for multi point appliances
- Table 105 – Flow pressure and flow rate for single point appliances [Go to Page]
- Table 106 – Pressure difference and flow rate [Go to Page]
- Table 107 – Pressure difference and flow rate [Go to Page]
- Table 108 – Behaviour at switch-on of the appliance at different temperature selector settings [Go to Page]
- Table 109 – Behaviour at switch-on of the appliance at different settings [Go to Page]
- Table 110 – Behaviour following the change of the flow rate at different temperature selector settings [Go to Page]
- Table 111 – Behaviour following the change of the flow rate at different settings [Go to Page]
- Table 112 – Behaviour following interruption of the flow [Go to Page]
- Table 113 – Behaviour following interruption of the flow [Go to Page]
- Table 114 – Behaviour at constant temperature setting [Go to Page]
- Table 115 – Behaviour following the change of the temperature selector setting at a flow rate of 50 %
- Table 116 – Behaviour following the change of the temperature selector setting at a flow rate of 100 % [Go to Page]
- Table 117 – Behaviour at voltage limits
- 7.101 Additional tests for electronic instantaneous water heaters [Go to Page]
- Table 118 – Behaviour of the outlet temperature at decreasing water inlet temperature [Go to Page]
- Table 119 – Behaviour of the outlet temperature following the increase of the water inlet temperature
- Annex A (normative) Load pattern
- Annex B (normative) Test setup
- Figure B.103 – Test setup
- Figure B.104 – Damping device (Detail 4)
- Figure B.105 – Water connection part (Detail 5)
- Figure B.106 – Water connection part (Detail 6)
- Annex ZZA (informative) Relationship between this European Standard and the energy labelling requirements of Commission Delegated Regulation (EU) No 812/2013 aimed to be covered
- Table ZZA.1 – Correspondence between this European Standard and Commission Delegated Regulation (EU) No 812/2013 of 18 February 2013 supplementing Directive 2010/30/EU of the European Parliament and of the Council with regard to energy labelling of wa...
- Annex ZZB (informative) Relationship between this European Standard and the ecodesign requirements of Commission Regulation (EU) No 814/2013 aimed to be covered
- Table ZZB.1 – Correspondence between this European Standard and Commission Regulation (EU) No 814/2013 of 2 August 2013 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for water he...
- Bibliography [Go to Page]