eLibrary >
BS ISO 16611:2017 Plastics piping systems for drainage and sewerage without pressure. Non-circular pipes and joints made of glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resins (UP). Dimensions, requirements and tests >
BS ISO 16611:2017 Plastics piping systems for drainage and sewerage without pressure. Non-circular pipes and joints made of glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resins (UP). Dimensions, requirements and tests, 2017
- National foreword
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 General requirements
- 4.1 Classification
- 4.1.1 Categories
- 4.1.2 Nominal size
- 4.2 Materials
- 4.2.1 General
- 4.2.2 Reinforcement
- 4.2.3 Resin
- 4.2.4 Aggregates and fillers
- 4.2.5 Elastomers
- 4.2.6 Metals
- 4.3 Wall construction
- 4.3.1 Inner layer
- 4.3.2 Structural layer
- 4.3.3 Outer layer
- 4.3.4 Appearance
- 4.4 Reference conditions for testing
- 4.4.1 Temperature
- 4.4.2 Properties of water for testing
- 4.4.3 Loading conditions
- 4.4.4 Conditioning
- 4.4.5 Measurement of dimensions
- 4.4.6 Elapsed time for determination of long-term properties, (x)
- 4.5 Joints
- 4.5.1 General
- 4.5.2 Types of joint
- 4.5.3 Flexibility of the jointing system
- 4.5.4 Sealing ring
- 4.5.5 Adhesives
- 5 Pipes
- 5.1 Geometrical characteristics
- 5.1.1 Dimensions
- 5.2 Mechanical characteristics
- 5.2.1 General
- 5.2.2 Short-term bending modulus
- 5.2.3 Long-term creep bending modulus
- 5.2.4 Short-term bending strength
- 5.2.5 Long-term bending strength
- 5.2.6 Resistance to strain corrosion
- 5.2.7 Minimum initial longitudinal tensile strength
- 5.3 Marking
- 6 Fittings
- 6.1 All types
- 6.1.1 General
- 6.1.2 Diameter series
- 6.1.3 Mechanical characteristics of fittings
- 6.1.4 Installed leak tightness of fittings
- 6.1.5 Dimensions
- 6.2 Marking
- 7 Joint performance
- 7.1 General
- 7.1.1 Requirements
- 7.1.2 Test temperature
- 7.1.3 Dimensions
- 7.2 Flexible joints
- 7.2.1 General
- 7.2.2 Maximum allowable draw
- 7.2.3 Maximum allowable angular deflection
- 7.2.4 Maximum allowable misalignment
- 7.2.5 Flexible non-end-load-bearing joints with elastomeric sealing rings
- 7.3 Rigid joints
- 7.3.1 Wrapped or cemented
- Annex A (informative) Examples for static calculation
- Bibliography [Go to Page]