eLibrary >
ISO 24431:2016 Gas cylinders - Seamless, welded and composite cylinders for compressed and liquefied gases (excluding acetylene) - Inspection at time of filling >
ISO 24431:2016 Gas cylinders - Seamless, welded and composite cylinders for compressed and liquefied gases (excluding acetylene) - Inspection at time of filling, 2016
- Foreword
- Introduction
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Identification of cylinder owner
- 5 Filling inspection
- 5.1 General
- 5.2 Verification of serviceable condition of individual cylinders before filling
- 5.2.1 General criteria
- 5.2.2 Exterior condition
- 5.2.3 Interior condition
- 5.2.4 Cylinder tare
- 5.2.5 Calculation of weight of gas to be filled into the cylinder
- 5.2.6 Provisions for visually inspecting cylinders fitted with coverings
- 5.2.7 Verification of the integrity of permanent attachments
- 5.2.8 Verification of valve integrity and suitability
- 5.2.9 Provisions for palletized cylinders
- 5.2.10 Rejected cylinders
- 5.3 Verification during filling
- 5.4 Verification after filling
- 5.4.1 General
- 5.4.2 Verification of gas tightness
- 5.4.3 Verification of correct filling pressure
- 5.4.4 Verification of correct filling weight
- 5.4.5 Verification of valve protection
- 5.4.6 Verification of correct product labelling
- 6 Cylinders rejected for filling
- Annex A (informative) Residual pressure check
- Annex B (informative) Example of a procedure to establish a correct tare
- Bibliography [Go to Page]