Abstract

This specification covers bullet jacket preform cups made from UNS C22000 wrought copper alloy used for processing Types I-IV and Classes I-II bullet jackets. This standard contains information on chemical composition, grain size and testing requirements for the preform cups.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

Significance and Use

For the purposes of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value, or a calculated value, shall be rounded as indicated in accordance with the rounding method of Practice E29 .

1. Scope

1.1 This specification establishes the requirements for bullet jacket preform cups produced of Copper Alloy UNS No. C22000 for processing into bullet jackets of the following types and classes:

1.1.1 Type I Caliber 0.30.

1.1.2 Type II Caliber 0.45.

1.1.3 Type III Caliber 0.50.

1.1.4 Type IV As specified in the contract or order.

1.1.5 Class I Not annealed.

1.1.6 Class II Annealed.

1.2 Units Values stated in inch-pound units are to be regarded as standard, except for grain size, which is given in SI units. The values in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast

B846 Terminology for Copper and Copper Alloys

E3 Guide for Preparation of Metallographic Specimens

E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E112 Test Methods for Determining Average Grain Size

E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

E478 Test Methods for Chemical Analysis of Copper Alloys

Keywords

bullet jackets; commercial bronze cups ; UNS No. C22000; Ammunition; Brass; Bronze; Bullet jackets; Copper alloy--specifications; UNS C22000 (commercial bronze, 80%)

ICS Code

ICS Number Code 77.150.30 (Copper products)

DOI: 10.1520/B0131-12

ASTM International is a member of CrossRef.

ASTM B131