ASTM C357-94(2002)e1
Historical Standard: ASTM C357-94(2002)e1 Standard Test Method for Bulk Density of Granular Refractory Materials
SUPERSEDED (see Active link, below)
ASTM C357
1. Scope
1.1 This test method covers a procedure for determining the bulk density of granular refractory materials, commercial products which usually have particles that are retained on a 0.265-in. (6.7-mm) or coarser sieve.
Note 1This test method is not suitable for materials that hydrate in boiling water. Such materials may be tested in accordance with Test Method C493.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
Keywords
blotting cloth; boiling; bulk density; buret; granular refractor; material; non-hydratable; sheen; Bulk density; Density--refractory materials; Granular refractory material; Nonhydratable refractory material; Refractories (general); Sheen; Water displacement test;
ICS Code
ICS Number Code 81.080 (Refractories)
DOI: 10.1520/C0357-94R02E01
ASTM International is a member of CrossRef.
