ASTM D1015-05
Historical Standard: ASTM D1015-05 Standard Test Method for Freezing Points of High-Purity Hydrocarbons
SUPERSEDED (see Active link, below)
ASTM D1015
1. Scope
1.1 This test method covers a procedure for the precise measurement of the freezing points of high-purity hydrocarbons.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 5.1, 6.1 and 6.2 . Note 1
For the calculation of the molal purity of essentially pure compounds from measured freezing points and for procedures to be used for the sampling and determination of purity of certain specific compounds, see Test Method D 1016.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1016 Test Method for Purity of Hydrocarbons from Freezing Points
D1265 Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products
Keywords
crystallization; freeze point; LPG; pure hydrocarbons; purity; Freezing point--petroleum products/applications; Hydrocarbons--high-purity;
ICS Code
ICS Number Code 71.080.01 (Organic chemicals in general)
DOI: 10.1520/D1015-05
ASTM International is a member of CrossRef.
