ASTM D2291-98
Historical Standard: ASTM D2291-98 Standard Practice for Fabrication of Ring Test Specimens for Glass-Resin Composites
SUPERSEDED (see Active link, below)
ASTM D2291
1. Scope
1.1 This practice is intended for use in the fabrication of ring-type test specimens to be used in the evaluation of the mechanical properties of reinforcement and resins in a composite structure. The practice outlines the steps in the preparation of the test specimens, including the final specimen machining where applicable. Four final ring configurations are included.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1-There is no ISO equivalent to this standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D883 Terminology Relating to Plastics
D2290 Test Method for Apparent Hoop Tensile Strength of Plastic or Reinforced Plastic Pipe by Split Disk Method
D2344/D2344M Test Method for Short-Beam Strength of Polymer Matrix Composite Materials and Their Laminates
Keywords
composite; glass fiber; prepreg; ring samples; ring tensile testing; shear testing; specimen preparation; thermoset resin; Resins (composite); Specimen preparation (for testing)--aerospace materials; High modulus fibrous composites--resin-matrix;
ICS Code
ICS Number Code 83.140.10 (Films and sheets)
DOI: 10.1520/D2291-98
ASTM International is a member of CrossRef.
