ASTM D2739-97
Historical Standard: ASTM D2739-97 Standard Test Method for Volume Resistivity of Conductive Adhesives
SUPERSEDED (see Active link, below)
ASTM D2739
1. Scope
1.1 This test method covers the determination of the volume resistivity of resin-based conductive adhesives in the cured condition. The test is made on a thin adhesive layer as prepared in a bonded specimen. This test method is used for conductive adhesives that are cured either at room temperature or at elevated temperatures.
1.2 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values stated in either SI or other units shall be regarded separately as standard. SI equivalents to screw threads are shown in the figures.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D618 Practice for Conditioning Plastics for Testing
D907 Terminology of Adhesives
Federal Specification
QQ-B-626 Composition 22 Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://dodssp.daps.dla.mil.Keywords
adhesive; conductive adhesive; conductivity; resistivity; volume resistivity; Adhesives; Adhesives (electrical insulation); Conductive adhesives; Electrical insulating adhesives; Electrical resistance/resistivity--adhesives; Resin-based adhesives; Volume resistivity;
ICS Code
ICS Number Code 83.180 (Adhesives)
DOI: 10.1520/D2739-97
ASTM International is a member of CrossRef.
