1. Scope

1.1 This specification covers machine-made glass-fiber-reinforced thermosetting-resin pressure pipe manufactured by the centrifugal casting process. Included are a classification system and requirements for materials, mechanical properties, dimensions, performance, test methods, and marking.

Note 1The term 'fiberglass pipe' as described in Section 3 applies to both reinforced thermosetting resin pipe (RTRP) and reinforced plastic mortar pipe (RPMP).

Note 2Pipe covered by this specification has been found suitable for conveying gases, petroleum products, or corrosive fluids.

Note 3For the purposes of this standard, polymer does not include natural polymers..

1.2 The values given in parentheses are for information only.

Note 4There is no similar or equivalent ISO standard.

1.3 The following precautionary caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C33 Specification for Concrete Aggregates

D618 Practice for Conditioning Plastics for Testing

D883 Terminology Relating to Plastics

D1598 Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure

D1599 Test Method for Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings

D1600 Terminology for Abbreviated Terms Relating to Plastics

D2105 Test Method for Longitudinal Tensile Properties of Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Tube

D2143 Test Method for Cyclic Pressure Strength of Reinforced, Thermosetting Plastic Pipe

D2310 Classification for Machine-Made Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe

D2412 Test Method for Determination of External Loading Characteristics of Plastic Pipe by Parallel-Plate Loading

D2992 Practice for Obtaining Hydrostatic or Pressure Design Basis for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Fittings

D3567 Practice for Determining Dimensions of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe and Fittings

F412 Terminology Relating to Plastic Piping Systems

Keywords

entrifugally cast pipe-plastic; pipe-'fiberglass' (glass-fiber-reinforced thermosetting resin); centrifugally cast, spec., ; Fiberglass pipe; 'fiberglass' pipe-centrifugally cast, spec., ; Plastic pipe/tubing/fittings-reinforced thermosetting resin (RTR); pipe-'fiberglass' (glass-fiber-reinforced thermosetting resin); centrifugally cast, spec;

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/D2997-01

ASTM International is a member of CrossRef.