ASTM D3607-08
Historical Standard: ASTM D3607-08 Standard Test Method for Removing Volatile Contaminants from Used Engine Oils by Stripping
SUPERSEDED (see Active link, below)
ASTM D3607
1. Scope
1.1 This test method covers a standardized procedure for removing volatile materials such as gasoline and water from used engine oils prior to further oil analysis.
1.2 It also provides an estimate of such volatiles in used engine oils.
1.3 When an accurate value of the gasoline contaminant is required either Test Methods D 322 or D 3525 shall be used.
Note 1Test Method D 322 determines the amount of gasoline by distillation with water. Test Method D 3525 determines the amount of material boiling below the boiling point of n tetradecane by gas chromatography.
Note 2When the amount of gasoline is required to be known, the user of this test method is advised to determine which method is to be used. There are cases where D 3525 may be set as the referee method.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warnings, see 6.1 and 8.5.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D322 Test Method for Gasoline Diluent in Used Gasoline Engine Oils by Distillation
D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)
D3525 Test Method for Gasoline Diluent in Used Gasoline Engine Oils by Gas Chromatography
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products
D4177 Practice for Automatic Sampling of Petroleum and Petroleum Products
Keywords
contaminants; engine oils; gasoline dilution; used engine oils; water contamination;
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
DOI: 10.1520/D3607-08
ASTM International is a member of CrossRef.
