Significance and Use

The results obtained by this test method may serve as a guide in, but not as the sole basis for, predicting the possible performance of the particular glass-fiber-reinforced thermosetting resin laminate in the one-side exposure to the specific environment under evaluation. No attempt has been made to incorporate into the test method all of the factors that may enter into the serviceability of a glass-fiber-reinforced resin structure when subjected to chemical environments.

This test method provides for the determination of changes in the physical properties of the test panel and test media during and after the one-side exposure in the test media. Determination of changes include: Barcol hardness, appearance of panel, appearance of test media, flexural properties, and thickness.

1. Scope

1.1 This test method is intended for use in the evaluation of the chemical resistance of fiberglass-reinforced thermosetting resins that are subjected to one-side panel exposure to specific environments. It takes into consideration the coldwall effects and radiation losses of heat transfer through the laminate wall.

1.2 This test method is supplemental to Practice C 581 and does not supersede it. Note 1 - There is no known ISO equivalent to this standard.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C581 Practice for Determining Chemical Resistance of Thermosetting Resins Used in Glass-Fiber-Reinforced Structures Intended for Liquid Service

D790 Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials

D2583 Test Method for Indentation Hardness of Rigid Plastics by Means of a Barcol Impressor

Keywords

contact molded; corrosion resistant equipment; glass-fiber reinforced; laminate; reinforced thermosetting plastic (RTP); thermoset epoxy resin; thermoset polyester resin; thermoset vinyl ester resin;

ICS Code

ICS Number Code 83.120 (Reinforced plastics)

DOI: 10.1520/D4398-07

ASTM International is a member of CrossRef.

ASTM D4398