ASTM D4857-03
Historical Standard: ASTM D4857-03 Standard Test Method for Determination of the Ability of Lubricants to Minimize Ring Sticking and Piston Deposits in Two-Stroke-Cycle Gasoline Engines Other Than Outboards
SUPERSEDED (see Active link, below)
ASTM D4857
1. Scope
1.1 This test method evaluates the performance of lubricants intended for use in two-stroke-cycle spark-ignition gasoline engines that are particularly prone to ring sticking. Piston varnish and spark plug fouling are also evaluated.
1.2 The values stated in SI units are the standard. The values given in parentheses are provided for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B152/B152M Specification for Copper Sheet, Strip, Plate, and Rolled Bar
D93 Test Methods for Flash Point by Pensky-Martens Closed Cup Tester
D235 Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)
D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)
D874 Test Method for Sulfated Ash from Lubricating Oils and Additives
D2270 Practice for Calculating Viscosity Index from Kinematic Viscosity at 40 and 100C
D2622 Test Method for Sulfur in Petroleum Products by Wavelength Dispersive X-ray Fluorescence Spectrometry
D4052 Test Method for Density, Relative Density, and API Gravity of Liquids by Digital Density Meter
D4629 Test Method for Trace Nitrogen in Liquid Petroleum Hydrocarbons by Syringe/Inlet Oxidative Combustion and Chemiluminescence Detection
D4858 Test Method for Determination of the Tendency of Lubricants to Promote Preignition in Two-Stroke-Cycle Gasoline Engines
D4859 Specification for Lubricants for Two-Stroke-Cycle Spark-Ignition Gasoline Engines-TC
D4863 Test Method for Determination of Lubricity of Two-Stroke-Cycle Gasoline Engine Lubricants
D4951 Test Method for Determination of Additive Elements in Lubricating Oils by Inductively Coupled Plasma Atomic Emission Spectrometry
E230 Specification and Temperature-Electromotive Force (EMF) Tables for Standardized Thermocouples
G40 Terminology Relating to Wear and Erosion
ANSI Standard
ANSIMC96.1 American National Standard for Temperature Measurement Thermocouples Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.Keywords
air-cooled; engine deposits; lubricant; two-cycle gasoline engine;
ICS Code
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
DOI: 10.1520/D4857-03
ASTM International is a member of CrossRef.
