ASTM D6449-99
Historical Standard: ASTM D6449-99 Standard Test Method for Flow of Fine Aggregate Concrete for Fabric Formed Concrete (Flow Cone Method)
SUPERSEDED (see Active link, below)
ASTM D6449
1. Scope
1.1 This test method covers a procedure, used both in the laboratory and in the field, for determining the time of efflux of a specified volume of the fine aggregate concrete through a standardized flow cone and used for fabric formed concrete (FFC); however, the test method may also be used for other fluid concrete.
1.2 It is for use with fine aggregate concrete containing fine aggregate as define in Specification C 33.
1.3 This test method is intended for use with fine aggregate concrete having an efflux time 9 to 15 s.
1.4 The values stated in SI units are to be regarded as the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
C33 Specification for Concrete Aggregates
C39/C39M Test Method for Compressive Strength of Cylindrical Concrete Specimens
C94/C94M Specification for Ready-Mixed Concrete
C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)
C1064/C1064M Test Method for Temperature of Freshly Mixed Hydraulic-Cement Concrete
Keywords
fabric formed concrete; fine aggregate concrete; flow cone; time of efflux; Fabric-formed concrete (FFC); Fine aggregate; Fine aggregate concrete; Flow and flow rate--cement/concrete; Flow cone method;
ICS Code
ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
DOI: 10.1520/D6449-99
ASTM International is a member of CrossRef.
