ASTM E1069-85(2003)
Historical Standard: ASTM E1069-85(2003) Standard Test Method for Testing Polymeric Seal Materials for Geothermal and/or High Temperature Service Under Sealing Stress
SUPERSEDED (see Active link, below)
ASTM E1069
1. Scope
1.1 This test method covers the initial evaluation of (screening) polymeric materials for seals under static sealing stress and at elevated temperatures.
1.2 This test method applies to geothermal service only if used in conjunction with Test Method E 1068.
1.3 The test fluid is distilled water.
1.4 The values stated in SI units are to be regarded as the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1414 Test Methods for Rubber O-Rings
E1068 Test Method for Testing Nonmetallic Seal Materials by Immersion in a Simulated Geothermal Test Fluid
SAE Standard
ANSI/SAEAS568A Aerospace Size Standard for O-Rings Available from Society of Automotive Engineers (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.Keywords
extrusion stress; geothermal fluids; geothermal liquids; polymeric seal; polymeric seal material; pressure stress; static sealing stress; temperature stress; Geothermal resources; Insulating specimens; Polymers (nuclear applications); Static tests--plastics; Stress--plastics; Temperature tests--solar devices/applications;
ICS Code
ICS Number Code 91.100.50 (Binders. Sealing materials)
DOI: 10.1520/E1069-85R03
ASTM International is a member of CrossRef.
