ASTM E2415-05
Historical Standard: ASTM E2415-05 Standard Practice for Installing Piezoelectric Highway Traffic Sensors
SUPERSEDED (see Active link, below)
ASTM E2415
1. Scope
1.1 This practice covers the installation of piezoelectric tire-force sensors that are used to detect axles when counting, classifying, or weighing vehicles as part of a roadway traffic monitoring program. Piezoelectric sensors are often used in pairs and combined with other roadway sensors such as inductive loops to classify and weigh vehicles.
1.2 The practice applies only to piezoelectric tire-force sensors used for the detection of vehicle axles on a roadway.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only and are not considered standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E867 Terminology Relating to Vehicle-Pavement Systems
E1318 Specification for Highway Weigh-In-Motion (WIM) Systems with User Requirements and Test Methods
E1442 Practice for Highway-Traffic Monitoring
E1572 Practice for Classifying Highway Vehicles from Known Axle Count and Spacing
E1957 Practice for Installing and Using Pneumatic Tubes with Roadway Traffic Counters and Classifiers
Keywords
axle counts; piezoelectric sensors; traffic counters; vehicle axles; vehicle classifiers; vehicles;
ICS Code
ICS Number Code 93.080.30 (Road equipment and installations)
DOI: 10.1520/E2415-05
ASTM International is a member of CrossRef.
