ASTM F2174-02
Historical Standard: ASTM F2174-02 Standard Practice for Verifying Acoustic Emission Sensor Response
SUPERSEDED (see Active link, below)
ASTM F2174
1. Scope
1.1 This practice is used for routinely checking the sensitivity of acoustic emission (AE) sensors. It is intended to provide a reliable, precisely specified way of comparing a set of sensors or telling whether an individual sensor's sensitivity has degraded during its service life, or both.
1.2 The procedure in this practice is not a 'calibration' and does not give frequency-response information.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This practice does not purport to recommend one sensor manufacturer over another nor does it imply that one type of sensor will react differently from another when using this procedure.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E650 Guide for Mounting Piezoelectric Acoustic Emission Sensors
E750 Practice for Characterizing Acoustic Emission Instrumentation
E976 Guide for Determining the Reproducibility of Acoustic Emission Sensor Response
Keywords
acrylic rod; calibration; sensor; Acoustic emission (AE) testing; Acrylic sensor rod; Calibration--acoustic emission analysis instrumentation; Sensitivity criterion/response; Sensors; Verification ;
ICS Code
ICS Number Code 17.140.01 (Acoustic measurements and noise abatement in general)
DOI: 10.1520/F2174-02
ASTM International is a member of CrossRef.
