|
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS EN 50728:2024 2024This document defines the measurement and evaluation methods of rolling stock interference current emissions to demonstrate compatibility with track circuits. This includes rolling stock with or without traction equipment. The established limits for compatibility are defined in ERA/ERTMS/033281, PD CLC/TS 50238-2 or NNTRs as current flowing between the vehicle and the electric traction power supply system that can disturb the track circuit receiver, as part of the track circuit system. Additionally, the referred documents can define a minimum rolling stock impedance in order to guarantee compatibility between the electric traction power supply system and track circuits. This document is relevant to the interference current limits defined in the "frequency management" for track circuits as defined in ERA/ERTMS/033281. It is also applicable to the demonstration of compatibility with all other types of track circuits which have established compatibility according to EN 50617-1. Finally, the methodology defined in this document can also be applied to other track circuit types, including those for which the only requirements are defined in NNTRs. NOTE 1 Interface parameters between rolling stock and track circuits other than interference currents and impedance are out of the scope of this document. NOTE 2 For track circuits prone to wrong side failures additional precautions might be needed to mitigate safety risks. The necessary precautions and safety considerations are outside the scope of this document, but can be found in NNTRs.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|