EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Description of BS EN IEC 60947-2:2025 2025IEC 60947-2:2024 applies to circuit-breakers, intended to be installed and operated by instructed or skilled persons, the main contacts of which are intended to be connected to circuits, the rated voltage of which does not exceed 1 000 V AC or 1 500 V DC; it also contains additional requirements for integrally fused circuit-breakers. This document also applies to circuit-breakers with ratings at or below 1 000 V AC, additionally having one or more ratings above 1 000 V AC but not exceeding 1 500 V AC. This sixth edition cancels and replaces the fifth edition published in 2016 and its Amendment 1: 2019. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) suitability for isolation (see Clause 1); b) removal of the classification according to the interrupting medium, according to the design, according to the suitability for isolation (see Clause 4); c) adjustment of current settings with an external device connectable to the release (see 5.7.3); d) requirements for circuits with protective separation (see 8.2.3.8); e) additional tests for ground-fault overcurrent releases (see 9.3.4.2.5); f) additional tests concerning dielectric properties in tripped position (see 9.3.4.3); g) use of DC voltage for dielectric tests (see 9.3.4.6.2 and 9.4.6); h) tests of individual pole breaking capacity under phase-to-neutral AC voltage (see 9.3.11); i) improvement of measurement of power loss in Annex G; j) changes in EMC tests (see Annex J); k) introduction of CBI class W in Annex L.
About BSIBSI Group, also known as the British Standards Institution is the national standards body of the United Kingdom. BSI produces technical standards on a wide range of products and services and also supplies certification and standards-related services to businesses. |
GROUPS
|