|
EDITION
PUBLISHER
CONTENT TYPE
Act
Admin Code
Announcements
Bill
Book
CADD File
CAN
CEU
Charter
Checklist
City Code
Code
Commentary
Comprehensive Plan
Conference Paper
County Code
Course
DHS Documents
Document
Errata
Executive Regulation
Federal Guideline
Firm Content
Guideline
Handbook
Interpretation
Journal
Land Use and Development
Law
Legislative Rule
Local Amendment
Local Code
Local Document
Local Regulation
Local Standards
Manual
Model Code
Model Standard
Notice
Ordinance
Other
Paperback
PASS
Periodicals
PIN
Plan
Policy
Product
Product - Data Sheet
Program
Provisions
Requirements
Revisions
Rules & Regulations
Standards
State Amendment
State Code
State Manual
State Plan
State Standards
Statute
Study Guide
Supplement
Sustainability
Technical Bulletin
All
|
Content DescriptionOne of the most important choices when designing a cable tray system for corrosive or outdoor environments is the material. Steel cable tray with a Hot-Dip Galvanized after Fabrication (ASTM A123) finish has been used successfully for many years. Increasingly, however, aluminum is becoming the material of choice for cable tray systems. In these days of shrinking construction budgets, why would engineers, contractors, and end users choose aluminum cable tray, which typically has a slightly higher initial cost, over Hot-Dip galvanized steel cable tray? The answer lies in aluminum’s many advantages in design, installation, delivery, performance and total cost over the lifetime of the installationAbout NEMANEMA is an abbreviation for National Electrical Manufacturers Association. It is a trade association representing manufacturers of electrical products and equipment. NEMA develops and publishes industry standards for various aspects of electrical engineering, including enclosures, motors, and more. |
GROUPS
|
|
MADCAD.com
by Compu-tecture, Inc.
|
Contact Us
3000 Connecticut Ave, NW
Suite 200
Washington, DC 20008
+1 800.798.9296
+1 202.265.1940
|
|
Partnerships
|